Standard Fabricated Bucket Tooth for 2A Series Construction Equipment

Description

When you’re working loose dirt, loading gravel, or digging in soft ground, a good tooth makes all the difference between getting the job done and fighting your equipment. This 2A series fabricated bucket tooth gives your loader or excavator the bite it needs to penetrate material cleanly and fill your bucket faster. No more slipping off rocks or struggling with worn-down stubs that can’t grab hold.

What You’re Getting

• Fabricated steel construction that’s tougher than cast alternatives and handles impacts better
• Sharp, aggressive point design that cuts through material instead of pushing it around
• Standard 2A series sizing that fits most common bucket tooth systems
• Direct replacement design that installs without modifications or special adapters

Built for Real Dirt Work

This tooth is designed for the 2A series bucket tooth system used on a wide range of construction and agricultural equipment. Whether you’re running a tractor with a front-end loader, skid steer, or compact excavator, this tooth handles everything from moving feed and manure to digging drainage ditches and loading trucks. It’s the kind of tooth that earns its keep on farms, construction sites, and anywhere you need to move dirt efficiently.

Made to Last

Fabricated construction means this tooth is built from formed steel rather than cast metal, making it less likely to crack or break when you hit something hard. The welded construction creates a tooth that flexes slightly under impact rather than shattering, so you get more working life even in rocky or challenging conditions.

Installation Notes

Installation is straightforward—this tooth works with the standard 2A pin and adapter system. If you’re replacing a worn tooth, check your pin and adapter while you’ve got things apart. A worn pin can cause a new tooth to work loose, and it’s easier to replace everything at once than to do the job twice.