Drive Gear Roll Pin for John Deere Cotton Picker Spindle Shaft

Description

When you’re in the middle of cotton harvest and a spindle stops turning, it’s usually this little roll pin that’s gone missing. This 5/32″ x 1″ black roll pin locks the drive gear onto the spindle shaft, keeping everything spinning like it should. Without it, your picker loses that spindle and you’re looking at downtime when every day counts.

What You’re Getting

• Precision-sized 5/32″ x 1″ roll pin that fits exactly where the original went
• Black finish resists corrosion in the dusty, humid conditions of cotton harvest
• Spring steel construction that holds tight under the constant vibration of picker operation
• Direct replacement that installs in minutes with basic hand tools

Built for Cotton Harvest

This roll pin secures the drive gear on spindle assemblies in John Deere cotton pickers. The spindle shaft is what turns each individual picker spindle, and this pin is the critical link that transfers power from the gear to the shaft. It’s a small part with a big job in the cotton picking process.

Made to Last

Cotton picking puts a lot of stress on every component, and this roll pin is built to handle the constant rotation, dust, and vibration that comes with harvest season. The spring steel construction and proper heat treatment keep it locked in place even when things get rough in the field.

Good to Know

Before installing, clean out the hole in the spindle shaft and check that the drive gear moves freely. A punch and small hammer make removal of the old pin easier if it’s stuck. When installing the new pin, make sure it’s seated fully and flush on both sides for proper operation.