Description

When you’re running a chisel plow or field cultivator through tough ground, worn points mean uneven tillage and extra fuel burned. This 2-inch by 13-inch reversible chisel spike gives you that sharp, aggressive penetration you need to slice through crop residue and break up compacted soil layers. The best part? When one end wears down, just flip it around and keep going.

What You’re Getting

Two working edges in one point—flip it when the first side wears to double your field time
5/8-inch thick construction that won’t bend or break in rocky ground
V-point nose design cuts through residue and penetrates hard soil cleanly
Standard 1/2-inch bolt holes on 1-1/4-inch spacing fit most common shanks
13-inch length provides good soil mixing and residue burial

Built for Real Farm Work

This spike works great on tool bar shanks, coil shanks, and other low-clearance applications where you need aggressive soil penetration. Whether you’re doing primary tillage after corn harvest or working down a bean field for the next crop, this point handles the job. The 2-inch width gives you a good balance between soil disturbance and trash flow.

Made to Last

Farm ground is tough on tillage points, especially when you hit rocks or old fence posts. This spike is built from quality steel that holds its edge and won’t chip or crack under normal field conditions. The reversible design means you get twice the wear life compared to a single-sided point.

Good to Know

Installation is straightforward with standard plow bolts through the pre-drilled holes. Make sure your shank bolt spacing matches the 1-1/4-inch pattern before ordering. When you flip the point, take a minute to check your other wear parts—it’s a good time to replace worn bolt washers or shank guards while you’re at it.