Front Axle Shaft Dust Cover for Massey Ferguson 300 Series 4WD Tractors

Description

When you’re counting on your Massey Ferguson’s 4WD to power through muddy feedlots or steep hillside mowing, the last thing you need is dirt and water getting into those expensive front axle components. When these covers crack or go missing, you’re inviting contamination that leads to premature bearing failure and costly repairs on your front drive system. This 65mm replacement cover seals things up tight so you can get back to work.

What You’re Getting

• 65mm diameter fits precisely on MF 300 series 4WD axles – no guesswork on sizing
• Durable rubber construction flexes without tearing during normal shaft movement
• Protects CV joints and shaft seals from contamination that causes expensive failures
• Prevents moisture intrusion that causes rust and corrosion inside your axle components
• Direct replacement that maintains the protection your front axle was designed to have

Built for Real Farm Work

Your Massey Ferguson 300 series 4WD tractors are built for challenging conditions where two-wheel drive just won’t cut it. From muddy feedlots to steep hillside mowing, these tractors rely on their front-wheel assist to power through. Whether you’re running a 362 through wet spring fields or using your 390 for loader work, this cover keeps your front axle protected right where you need 4WD the most.

Made to Last

This cover uses heavy-duty rubber compounds that resist tearing from shaft movement and environmental damage. The material stays flexible in cold weather while resisting degradation from UV exposure and axle grease. The precise 65mm sizing ensures a snug fit that won’t work loose during operation. Unlike universal boots that don’t fit properly, this exact replacement maintains the protection your front axle was designed to have.

Installation Notes

Clean the shaft thoroughly before installation – old grease and dirt prevent proper seating. Check for shaft wear or damage that could cut the new cover. Lubricate the inside of the cover with rubber-safe grease for easier installation. Make sure the cover seats fully in its grooves to prevent water entry. A good tip: inspect these covers during every service since catching a small tear early saves expensive axle repairs down the road.