Description

When your disc harrow starts throwing blades or making noise that shouldn’t be there, it’s often because the washers at the end of the gang have given up. This heavy-duty washer spring keeps your discs properly positioned and tensioned on the gang, preventing them from sliding around and wearing out bearings or axles. Think of it as the part that keeps everything in line so your tillage equipment cuts clean furrows instead of making a mess.

What You’re Getting

Hefty 7-inch diameter spring washer that won’t compress under load
Made from 65Mn high-carbon, high-manganese spring steel for long life
Handles both 1-1/4 inch square and 1-1/2 inch round axles
3/8 inch thickness provides the right pressure without over-stressing the gang
Manufactured to OEM specs so it fits and functions like the original

Built for Real Farm Work

This washer spring is designed for any disc harrow running 1-1/4 inch square axles – that covers a lot of tillage equipment from different manufacturers. Whether you’re running an offset disc to work corn ground or using a tandem disc for seedbed prep, this washer keeps the gang components properly spaced and under the right tension for smooth operation.

Made to Last

Farm equipment washers take a beating from constant compression and release cycles, plus all the dirt and debris that gets thrown around during field work. The 65Mn spring steel construction handles the stress while maintaining its spring properties through thousands of cycles. This isn’t cheap metal that’ll fatigue and crack after a season or two.

Installation Notes

These washers go on the outside of the disc gang, usually held in place by a nut or retaining ring on the axle end. When replacing washers, check your gang spacing while everything’s apart – worn washers can let discs crowd together and wear unevenly. A quick tip: if one washer is shot, the others on that gang probably aren’t far behind.