Riveted Disc Bearing Assembly for John Deere Disc Harrows – 1-3/4 Inch Round Bore

Description

Nothing ruins field time faster than a disc bearing that’s gone bad. When your disc gang starts wobbling or making noise that carries over the tractor engine, it’s time for new bearings. This riveted disc bearing assembly is built to handle the constant pounding and side loads that come with working through tough residue and varying soil conditions.

What You’re Getting

• Heavy-duty riveted construction that stays together under field stress
• Greasable design lets you maintain it properly for long life
• Round 1-3/4 inch bore fits standard John Deere disc axles
• Quality sealing keeps dirt and debris out of the bearing races
• Direct replacement for worn factory bearings without modifications

Built for Real Farm Work

This bearing assembly is designed for John Deere disc harrows working everything from light finish work to heavy residue management. Whether you’re incorporating corn stalks, breaking up compacted ground, or preparing seedbeds, this bearing handles the job. It’s built for the kind of work disc harrows do best – cutting, mixing, and smoothing soil in all kinds of field conditions.

Made to Last

The riveted design means this bearing won’t come apart when the going gets tough. Quality steel construction and proper heat treatment handle the shock loads that destroy cheaper bearings. The greasable fitting lets you pump in fresh grease to flush out contaminants and keep everything running smooth season after season.

Good to Know

Regular greasing through the fitting is your best insurance for long bearing life – especially in dusty or muddy conditions. When installing, clean the axle thoroughly and check for any wear or gouging that could damage the new bearing. A little anti-seize on the axle helps with future removal, and always torque mounting hardware to spec to prevent the bearing from walking on the shaft.