Description

There’s nothing more frustrating than hitting the 4WD button when you’re stuck in a muddy field and watching your front wheels just spin freely. When your 4WD switch won’t engage properly or only works if you hold it just right, you know it’s time to replace it. This 4WD engagement switch gives you reliable control over your front axle, so you can count on getting the traction you need when the going gets tough.

What You’re Getting

Direct replacement for original equipment – no modifications needed
Heavy-duty electrical contacts that handle the load without burning out
Weather-resistant design keeps moisture and dirt from causing failures
Positive engagement action eliminates guessing whether 4WD is really on
Built to handle thousands of cycles without wearing out

Built for Real Farm Work

This switch fits Case Maxxum and Puma series tractors along with New Holland T6, T6000, and T7000 models. Whether you’re pulling implements through heavy ground, doing loader work on soft surfaces, or need extra grip on slopes, these tractors depend on reliable 4WD engagement to get the job done without getting stuck.

Made to Last

Farm switches take a beating from dust, moisture, vibration, and constant use. This replacement uses sealed construction to keep contaminants out and heavy-duty internal components that won’t fail when you need them most. The electrical contacts are rated for the amperage your 4WD system demands without arcing or sticking.

Installation Notes

Always disconnect the battery before starting electrical work. The switch location varies by model but is typically in the dash or control panel. Take a photo of the wire connections before disconnecting – it’ll save you time and frustration during installation. Clean any corrosion from the terminals while you’re at it.