Description

When you’re setting up your cultivator or working on older tillage equipment, having the right mounting hardware makes all the difference between a job done right and one that’ll give you headaches down the road. This heavy-duty foot piece is what connects your shank to the toolbar, and it’s built to handle the forces that come with working tough ground and dealing with rocks, roots, and whatever else your fields throw at you.

What You’re Getting

Fabricated from 3/8 inch steel that won’t bend or crack under field conditions
Front and rear mounting plates distribute stress evenly across the toolbar
Pre-drilled for 11/16 inch bolts with 4 inch center-to-center spacing
Inside width of 1-1/8 inch fits standard 1×3 inch shanks with room for proper clearance
11-3/4 inch overall length provides solid mounting surface and proper geometry

Built for Real Farm Work

This foot piece works with Hamby, Roll-A-Cone, C&J, and other popular cultivation equipment that uses 1×3 inch shanks. Whether you’re cultivating corn, beans, or working ground for next season’s crop, this mounting bracket handles the job. It’s designed for the kind of equipment farmers rely on for weed control and seedbed preparation.

Made to Last

The 3/8 inch steel construction isn’t just heavy—it’s the right thickness to flex slightly under load without breaking, which is exactly what you want when you hit something solid in the field. The fabricated design with front and rear plates spreads the load better than lighter brackets that can work loose or crack at stress points.

Good to Know

This is a direct bolt-on replacement that uses standard 11/16 inch bolts for mounting. Make sure your toolbar can accommodate the 4 inch center-to-center hole spacing before ordering. When installing, use Grade 8 bolts and check them after a few hours of field time—new mounting hardware often needs a retightening once it settles in.