Description
When your combine’s cutter bar starts leaving stubble higher than you’d like or you’re dealing with bent or worn sections, it’s time for replacements. A sharp, properly functioning cutter bar is what separates a clean cut from a ragged mess that can slow down your harvest and leave valuable grain in the field. This fine tooth serrated section gets your Massey Ferguson Lickity-Split combine cutting cleanly again.
What You’re Getting
- Fine tooth serration with 14 teeth per inch for clean cuts through tough stems
- Top serrated design that grabs and holds crop while cutting
- Heavy-duty plated finish that resists wear and corrosion
- 3-inch length with 2-inch hole spacing for standard mounting
- 7/32 x 5/8 fastener size fits your existing hardware
Built for Real Farm Work
This section is designed specifically for Massey Ferguson Lickity-Split combines, machines that earned their reputation for reliability in small grains and soybeans. Whether you’re cutting wheat, barley, or beans, the fine tooth design handles varying crop conditions while maintaining consistent cutting performance throughout long harvest days.
Made to Last
The plated finish and heavy-duty construction mean this section stands up to the constant vibration, impact, and moisture that come with combine harvesting. KONDEX builds these sections to handle everything from green stem soybeans to dry, brittle wheat without losing their edge or breaking under stress.
Good to Know
Installation is straightforward using your existing mounting hardware. When replacing sections, it’s smart to check the condition of your hold-down clips and guards at the same time. A quick tip: keep a few spare sections on hand during harvest season—finding a bent section at 9 PM when you’re trying to finish a field is never convenient.
Reviews
There are no reviews yet.