Description
When your old Ford 600 or 700 is struggling to idle smooth or hesitating under load, it’s usually time to rebuild or replace that carburetor. These mid-1950s tractors came with Marvel-Schebler TSX580 carburetors from the factory, and after 60-plus years, those original units have seen their share of gummed-up fuel and worn parts. This complete replacement assembly gets your tractor running like it should again.
What You’re Getting
- Complete carburetor assembly ready to bolt on—no rebuilding required
- Proper 2-1/4 inch center-to-center stud spacing for direct replacement
- All internal components are new, including float, needle valve, and gaskets
- Quality construction that handles the demands of farm work
Built for Real Farm Work
This carburetor fits Ford 600 and 700 series tractors from 1955-1957 with the 134 cubic inch gas engine. Whether you’re using your tractor for hay work, cultivation, or general farm chores, these were the workhorses that got the job done on smaller farms. The 134 CID engine was known for being reliable and economical, perfect for tractors that spent their days on row crop work or powering smaller implements.
Made to Last
Farm tractors don’t get babied, and carburetors take a beating from dust, moisture, and temperature swings. This replacement unit is built with quality materials and precision tolerances to handle whatever your farm throws at it. The float chamber seals properly, the throttle shaft fits tight, and the mixture screws adjust smoothly for years of reliable service.
Good to Know
Installation is straightforward—just remove the old carburetor and bolt this one in its place. Make sure to clean the intake manifold surface and use a new gasket for a proper seal. You might need to adjust the idle mixture and governor linkage to get everything dialed in just right. A good tip is to drain the old fuel and start fresh when you install the new carb.
Reviews
There are no reviews yet.