Description
When you’re hooking up that hay trailer or utility hauler, the last thing you want is to be cranking away with a flimsy jack that’s fighting you every step of the way. This Bulldog side wind trailer jack gives you reliable lifting power with the convenience of a crank handle that’s right where you need it—no crawling around to the front of the trailer to wind it up or down.
What You’re Getting
- Side wind operation keeps you clear of the hitch area while cranking
- 2,000 lb capacity handles most farm and utility trailers with room to spare
- 10 inches of lift range gets your coupler to the right height for any truck
- Tube weld mount gives you a permanent, rock-solid mounting system
- Large 7.5 x 3.9 inch foot plate spreads the load and won’t sink into soft ground
Built for Real Farm Work
This jack is sized right for the trailers you’re likely pulling around the farm—livestock trailers, hay wagons, utility flatbeds, and equipment haulers. The round tube design is simple and dependable, without the complexity of swivel mounts that can wear out or get gummed up with mud and grease.
Made to Last
Bulldog builds these jacks to handle the rough life of farm and ranch work. The side wind gear system is protected inside the housing where it won’t get packed with dirt, and the tube mount design distributes stress better than bolt-on brackets that can work loose over time.
Installation Notes
The tube mount welds directly to your trailer frame for a permanent installation. Make sure you position it where the foot plate will have good ground contact when the trailer’s unhitched. A quick tip—weld it slightly forward of where you think you need it, since most folks end up wishing their jack was positioned a little closer to the tongue.
Reviews
There are no reviews yet.